Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Well, dont I feel like a real idiot.........The red wire on the E0 connector that plugs into the Duet was broken inside the connector. I found when I was moving the connector to E1.....
You can't print an STL file directly, you need to slice it first and then upload and print the .gcode file that the slicer generates.
1. Which versions of main firmware and wifi firmware are you running? Perhaps they are mismatched.
2. Maybe the SD card is corrupted? Put it in a PC and run a disk checking tool on it.
All the files in /sys should be visible in the system files editor.
