I've had it with the mini-rambo 1.3a board that has been giving me problems over the past few months, and thought that a Duet 3d board might just be the way to go.
Since my Prusa runs on 12 volts, is this supported on the duet? I had read that the ideal is to use 24volts, but since my bed, power supply, heater cartridge, thermistors, steppers and pinda probe are 12 volts, I would rather not have to replace everything if possible.
Is it possible to do this conversion? If so, I will likely take the time to design a proper mount for it in my prusa and for other 2.5s users looking to convert, and provide a detailed step-by-step guide for those looking to switch over to a more powerful board.