Thanks, config file is now back but still at a road block on the post processor. RepRap looks very different to mach 3 code?

@danal - any luck with the post processor?

My Config.g file has disappeared, is it easy to recover?

Are you using cncjs as the control software or are you using the web interface to run code?

Thanks

Luke

@danal Thanks for confirming my thoughts.

Ok, I need to spend some more time in the web interface and review the settings. I was more intent on getting switches and motors working. Is there one screen that shows every setting a bit like UGCS and the machine settings?

Which post processor are you using?

Also have you developed any macro's or probing commands?

Lastly do you use a spindle with your setup or a router?

Thanks

Good day!

I'm looking at using the Duet 2 board for a CNC. I have setup the board through the web interface and had a little play, however at present and noted by other members the web interface is very 3d printer related and I can't see any way to change that.

To make things simple and move forwards I'm looking to control the board over USB as an interim and found the CNCJS in Marlin mode allows for basic connectivity.

Is it possible to open up all the default machines settings on the board to 'configure' my cnc setup i.e. limits/travels etc

Also has anyone played with fusion 360 post processors?

Thanks

Luke