Posts made by Oleksii_Solntsev

undefined

Yes. I definitely made a mistake.

We use HTD 3M 15 PU belt. And the EMF calculations looks so..

how can i interpret the results i got?
Thanks!

undefined

Thank you so much!
We have parallel kinematics.
https://smartzavod.com/
Here is the landing page of our startup)

And I tried to figure out all Parameters (like belt characteristics) and made the calculation.
but I definitely lack the expertise to understand the output and make any conclusion. Could you recommend a resource where I could read more about this?)

but if simple.
if we use our printer at speeds up to 400mm / s, then according to this calculation the driver should withstand?

Thank you.

undefined

Hi everyone!

I would be grateful for your help in choosing motors for our new printer that we want to launch on Duet3D)

We assemble our printer on ready-made CCM belt-driven modules.

Can native mainboard drivers Trinamic 5160 (4.45A RMS, 6.3A peak) handle the 57CM3 Nema23 stepper motors? (specification below)

Thanks for support!

Best regards,
Oleksii