Posts made by paulcdb

oooooh....

It's G30 instead of G28 for homing Z I guess.

Spent a week scratching my head... my brain's slow!

I have a HEVO and setup independent z axis which seemed to be working ok until I updated the firmware which screwed up a lot of the settings due to some changes and I have it mostly working again except the z 'error' keeps increasing when I home.

G28
Error: Some computed corrections exceed configured limit of 2.50mm: -43.270 -42.905

G28
Error: Some computed corrections exceed configured limit of 2.50mm: -49.359 -48.986

G28
Error: Some computed corrections exceed configured limit of 2.50mm: -55.497 -55.167

G28
Error: Some computed corrections exceed configured limit of 2.50mm: -66.454 -66.181

these are one after another and it seems to be constantly adding some stored value. Is there something I need to add to reset whatever is going on?

I've been through each file and can't see anything that's being added and they all have 8/8 for last modified so it seems to store it somewhere besides the config files.