Posts made by PhoenixSimon

@bearer
thank you very much. I highly appreciate your help.

@bearer
Hi
I have seen you have mentioned you can put the capacitor on the motor, on the connector and on the board.
What is the proper and safest way to do this?
I have connected the capacitor to the connector just to try the servo but it doesn't look very professional and safe.
How could I connect the capacitor to the board?
What else would you suggest?

thanks

Ok thanks I will ask my supplier immediately to replace the board and I will link to this conversation.

Thanks again
Andras

So thanks for your quick reply I highly appreciate it.
I have removed the M301 command from config.g and I have restarted the Duet but unfortunately there was no difference. Still received the Heating fault on heater 1 temperature rising much more slowly than the expected 3.6°C/sec.

I have attached to this post the conig-override.g file. See if there is something what shouldn't be.

Thanks
0_1558978192063_config-override.g

Hi
I would like to get some help with my new Duet 2 Wifi board. Unfortunately since day one I cant heat up the E0 terminal but the same heater cartridge works in the E1 terminal. I get good temperature readings from both thermistors but I don't know why it is not working. The E0 LED is not lighting up if I try to turn the heating on. The E1 LED works. Auto tune fails after a few minutes as it is not heating properly.

I need to mention that the E0 green terminal is wobbling a bit since I have received the board but I think it can hold the crimped wires down properly only the green plastic cover is moving up and down slightly.
The E1 is not wobbling that looks solid, whenever I tightened the screws I held the terminal to makes sure not to damage it.

So I really don't know what can I do.
I have attached the config file.

Please I would be really happy to get some help.
THANKS
0_1558808869166_config.txt