@bearer said in Duet 2 Ethernet - problem with DWC:
What other options do you have for
"Manually" with mask 255.255.255.0 worked.
@bearer said in Duet 2 Ethernet - problem with DWC:
What other options do you have for
"Manually" with mask 255.255.255.0 worked.
I dumped the DHCP and forced the mask to 255.255.255.0 and now the thing seems to be working!
The only change that has happened between now and the last time I used the Duet is a Mac OS update so I guess something got messed up then.
I'm quite bad with computers and networks so Thanks a million!
@bearer said in Duet 2 Ethernet - problem with DWC:
actually, if you're using DHCP and getting a /32 address something is a bit strange. What does the ethernet cable from the usb ethernet adapter on the mac(?) connect to?
Directly to Duet
Sorry for having these in Finnish...
USB LAN (ethernet) seems to be ok. Duet is there too (I didn't put it in there though, that just showed up) but cannot be connected to.
Only USB in the first posts.
DHCP - yes and fixed IPs.
Now I disconnected the USB, connected the ethernet and powered up the Duet - response to ping still the same.
Also this happens, still on USB and Ethernet cable disconnected:
I should be able to ping it right?
Good to know that the card and socket are ok.
I haven't removed or renamed any of the files on the SD. However I copied the reprap.htm and renamed it as index.htm - no change.
@bearer said in Duet 2 Ethernet - problem with DWC:
@PL said in Duet 2 Ethernet - problem with DWC:
reprap.htm is there and works when opened directly from SSD but not through USB.
SSD presumably means SD as in SD card?
And by through USB you mean sending
M20 P/www
to the duet serial console you do not see the file? If so share the output ofM122
Yes, SD card. Sorry.
I can see the files in the console but DWC won't start in browser. Here's the M122 output:
...the above is a screen shot from the laptop because the listing in terminal looks like this:
reprap.htm is there and works when opened directly from SSD but not through USB.
Hi!
I left my CNC router unused for a month or two, and now I can't get the DWC started. It worked just fine last time... When connected via USB it seems that the IP address is correct and firmware is running - doesn't that tell that the SSD card and socket are ok?
Still, my browser times out when trying to open the DWC (the files that should be on the SSD are there and open ok in a laptop)
Thank you in advance for any ideas.
Pete