@theBAHNFreak I had a similar Issue with a Toolboard 1LC v1.2 after disconnecting everything from the board I still got the same bad Vssa error so I checked the schematics and measured the board. I found that the Resistor R47 had a value in the range of 2.2kOhm instead of 10Ohm and replaced it. After that, the temperature reading on both temp0 and temp1 was working.
![](/assets/uploads/system/avatar-default.png?v=1521803371351)
Best posts made by Poglitst
-
RE: Heater reads 2000° and error Bad Vssa
Latest posts made by Poglitst
-
RE: Heater reads 2000° and error Bad Vssa
@theBAHNFreak I had a similar Issue with a Toolboard 1LC v1.2 after disconnecting everything from the board I still got the same bad Vssa error so I checked the schematics and measured the board. I found that the Resistor R47 had a value in the range of 2.2kOhm instead of 10Ohm and replaced it. After that, the temperature reading on both temp0 and temp1 was working.