M305 P1 T100000 B4267 R4700 H0 L0

Sorry for the delay I have been away from home

That did it DC… thank you very much!

Duet 0.8.5 1.1.9
NPN install on E0

My HomeZ.G Looks Like this:

G91 ; relative mode
G1 Z4 F200 ; raise head 4mm to ensure it is above the Z probe trigger height
G90 ; back to absolute mode
G1 X110 Y102 F2000 ; put head over the centre of the bed, or wherever you want to probe
G30 ; lower head, stop when probe triggered and set Z to trigger height

When I use homez.g it moves to x and y properly but when G30 Executes in moves X negative until it hits the endstop and keeps going for a few MM it will move the Z - and the probe will stop the Z.

I would like for it to use the offsets properly and probe the proper center of the bed….

Any ideas? Below is my lines in my Config.g

M574 X1 Y1 Z0 S1
M208 X0 Y0 Z0 S1
M558 P4 X0 Y0 Z1 H3 F200 T5000 R0
G31 P500 X50 Y30 Z0

Thanks!

I do not have the board currently installed, I swapped to my Duet 0.8.5….. I can reinstall it if needed...

Thanks!
Chad

It does not change. Its always 100c

Hi all,

I haven't been able to touch my printers since I moved in January so Im just getting to this.. I email DC back in January with this issue and said to bring it to the forum…

I turned my printer on one day and found the hotend temp reading 100C constantly.. it does not change... Any ideas?

Thanks!

Chad