Fixed the issue with upgrade.
Thank you DC42 and everyone for the heads up. Should have done an upgrade from the start..
Fixed the issue with upgrade.
Thank you DC42 and everyone for the heads up. Should have done an upgrade from the start..
Thank you all for the fast response.
I checked the firmware version. the board has 2.0(RTOS) (2018-06-05b3) .
I will upgrade to the newest and see what happens.
Thanks again for the point in the right direction.
Hello All,
I am using a Duet for a non 3d printer project but the application sends a G0 command to the Extruder such as: G0 E120 F200. It is sending the T0 command as well before the move command.
I have checked in the web ui that I can move the extruder axis via G1 E120 F200 but I can not G0.
Any idea's?
Thanks in advance for your assistance.