@cjm Thank you so much for the help. As it turns out I think I made the same mistake twice but this time I caught it after looking at your screen share. I loaded the DuetWebControl-SBC.zip instead of DuetWebControl-SD.zip and DWC stayed 3.3.0 versus 3.3.0-CNC08. I'm kinda embarrassed to admit it but hopefully if someone else makes this mistake they'll find the solution here.
Posts made by Redvernon
-
RE: Duet Wifi CNC Status Offposted in CNC
-
RE: Duet Wifi CNC Status Offposted in CNC
@cjm you are correct that I had the board powered from the usb while making some changes to a static ip and that caused cnc mode to be off. But even now with the Vin powered the only thing that changed was it went to idle mode, there's still no workzero buttons. I'm running 3.4 beta2 and it has the "combined firmware.bin" file installed.
-
Duet Wifi CNC Status Offposted in CNC
I have a Duet Wifi running version 3.4 firmware that I can't get CNC mode to work. I have a M453 command in my Config.g and it's in CNC mode but status is "off" so I have no workzero buttons. What am I doing wrong?
