@fcwilt
Thank you very much! It ended up being just over 2600 so I was way off.
I appreciate your time!

@fcwilt
Thank you very much! It ended up being just over 2600 so I was way off.
I appreciate your time!

@reellife
Is that correct or am I just reading somthing wrong?
My understanding is if I entered that into the M208 it would change axis limits not the steps per mm

@fcwilt
I had to leave the lab that the printer is in but I will check this out in the morning

according to my code the M208 command is the axis limits and M92 is the steps per mm

@fcwilt I Meant 305 for the x y and 457 is the true z setting according to the original build volume. I believe it will be more like 350 after I finish mounting the heated bed

@fcwilt
Thanks for your help I'm new to the scene. im not sure what you meant by </> but I attached my files as best I could.

</>tpre0.g tpost0.g tfree0.g stop.g sleep.g resume.g pause.g homez.g homey.g homex.g homeall.g Duet2CombinedFirmware.bin config.json config.g bed.g

@fcwilt
Im talking total build volume I messed with the steps per mm and it did not fix the problem.
the printer is 350 x350 x450 the X and Y work perfectly but the Z is all messed up If I move it down it will just stop like it hit an invisible end stop at about a 1/6th of the way down.

the steps per mm is at 400 Rn

Hello!
I am Currently upgrading a MakerBot Z18 replicator I bought a duet 2 wifi board and I am having some issues with the Z axis. its a Core XY printer, It has one motor running the Z-axis and I believe the problem has to do with what appears to be gear ratio that's about a 1:6. smaller gear on the stepper. so when I put in the Z to 450 it only goes about a 6th of the way. If i set it to 2700 it goes just about all of the way down but as it is only 450 mm I'm assuming this will mess up my prints. does anyone have any ideas? I'm spending way too much time on this LOL.