Posts made by Rik_Groen

Replacement board has arrived and is working great thanks again for the great support

Thanks for the help, I will send an email for the warranty.

I have set the acceleration to 1 mm/s^2 and still the same problem.

When I change the Y and Z drivers the Y axis wont move anymore and the Z axis will move, so I think that, as you discribed above, the Z driver is only powering one phase. Is there any way how that can be solved?

Hello,

I recently recieved my deut wifi (5th batch preorder), unfortunaly i cant get my z-axis to turn they only vibrate (going really fast from left to right). The y-axis, x-axis and extruder are working normally as you may expect. I personally think its a wiring problem, because they get current but I can't find exactly what I'am doing wrong. The things I tried so far are as following:
-Check the wiring (these are the same as my other axes).
-Changed the wire with a wire of a motor that works.
-Changed the motor with a motor that works.
-Removed the load.
-Attach just 1 motor.
-Ramped the current up to 2 amps, I dont want to give it more than that and currently its back at 1.5 amps.
-Re-installed the firmware.

I also added some pictures (in the db link below) of the wiring as i thougt it suposed to be. Also there is a picture of the back of the board since I want to know where L1 and L2 stand for. These can be found by the pins of the z-axis, can these also be related to my problem.
https://www.dropbox.com/sh/bebovoejcxmzctj/AAD3RIh5l7wUH2gvcP7tGh37a?dl=0

Hopefully anyone can help me so I can print again.
If there is any thread related to this problem, please let me know because I could not find it.