Posts made by sbcrumb

Thank you that fixed it, I must have missed I needed to move my M350 and M92 commands after my M584.
I will look at my M593 and fix that, I am at least printing again and that is the important part.

I recently upgraded from 3.2 stable to 3.3RC2, and I can't print. My first layer is terrible. Seems like it is not extruding properly and I also get these errors in my start up.

power up + 00:00:00 [warn] Error: in file macro line 35 column 19: M350: array too long, max length = 0
power up + 00:00:00 [warn] Error: in file macro line 37 column 6: M92: array too long, max length = 0
power up + 00:00:00 [warn] Error: in file macro line 85 column 11: M593: expected string expression

Which I don't get on 3.2 Stable Release.

Attached is my config and a first layer picture.

Config
Config.g

@IdefixRC
Not sure if you every got this fixed, but I noticed I would only get this message when nothing was printing. IE Idle state has no status but printing messages came through.