@dc42 Have you heard of anyone experimenting on the speed at which the stream will work? Just wondering how many lines need to be buffered at a time. In this scenario, the "printer" is acting as part of a dynamic system and its code / function might need to change depending on sensor going to a higher level controller in the system.

@achrn Gotcha!
I am hoping to get some data back from the system in semi-real-time (0.2 seconds or so) so I will do some experimenting and see if how it affects the motion.

@achrn Interesting, thank you!

Do you happen to know the type of speeds you could achieve for continuous calls from the on-board HTTP interface? Would sending too many requests slow down the rest of the system?

Hello!

I am fairly new to Duet3D and RRF. I have an application where I would like to control multiple "3D Printers" via a single PC / Linux server. I know that with Klipper, you can directly control hardware over USB from a central computer (sbc or otherwise).
I already have a Duet3 Mainboard 6HC and was wondering if it was possible with this board.

Is it possible to send hardware commands over ethernet or usb to the Duet3 Mainboard?
Would I be better off getting a Klipper setup?

Thanks!