Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. smunter
    • Profile
    • Following 0
    • Followers 0
    • Topics 0
    • Posts 1
    • Best 0
    • Controversial 0
    • Groups 0

    smunter

    @smunter

    0
    Reputation
    1
    Profile views
    1
    Posts
    0
    Followers
    0
    Following
    Joined Last Online

    smunter Unfollow Follow

    Latest posts made by smunter

    • RE: Duet3D PCB delta printer effector sneak preview

      I'm in for one once this gets going as well.

      I know adding an IMU was discussed earlier for autolevelling and calibration purposes, but I would another potential use as well: magball disconnect detection. It should be very easy to tell if the effector goes out of level by more than 10 degrees or so, and shut down the printer so no more damage is done. I would take an IMU on board for that purpose alone.

      posted in Smart effector for delta printers
      smunterundefined
      smunter