Topics created by Sotidii

@sotidii said in LIS3DH +SAMMYC21(chip45)+Duet 3 Mini:

Is it possible to connect BLtouch to Sammyc21

Yes, it's possible. See the pin table at https://duet3d.dozuki.com/Wiki/Using_the_Sammy-C21_development_board_with_Duet_3#Section_Features_of_the_standard_firmware_binary. Pick a pin capable of PWM output for the servo control wire, and a pin capable of digital input for the input pin.

@dc42 said in Duet3d DHT 22:

BTW we already allow a redundant "0." prefix to be used in front of drive numbers on Duet 2. I will probably allow the same for port names in a future release.

All working fine for me now - Thanks!