Topics created by st3phen

@st3phen I think the Dire warning is because people will try to disable the heater protections when it doesn't work at first which is where the fire risk comes from.

If you can derive sane values for the thermistor based on what you know about it, you should be ok.

This ended-up being an issue with my understanding of the calibration process, apparently. Every time I moved the nozzle down to Z=0 via the G1 Z0 command, it introduced error into subsequent measurements.

I abandoned that and moved to a process of
G1 Z10
G30 S-1
G1 Z10, etc.

That proved to get amazing repeatability. In fact, using the "Measure Probe Repeatability" test results in STDV of 0.003!