Yes, but if I only change the connector from drive 0 to drive 5, it is not a problem with the configuration, engine wiring. I have tried it with the current wiring and a new one and I keep getting the same fault !!
Posts made by STCabrera
-
RE: Short-to-ground on driverposted in Hardware dev
-
Short-to-ground on driverposted in Hardware dev
Short-to-ground on driver
Hello, good morning, I have acquired a Duet 3, I have configured it and when I have to activate driver 0 (Extruder) I get the message Short-to-ground on driver.
But if I connect the cable in dirver 5, which is the one that was free, I don't get the Short-to-ground on driver fault. I think it is the driver that is defective, what do you think?
Greetings and thank you!!!