YES, in 8 work. thx

@bearer yes, work. install beta11

@dc42

M574 X1 S1 P"io0.in" or
M574 X1 S0 P"io0.in"
on beta11 always triggered YES.

IF RUN "M574 Y2 S0","M574 X1 S0" work fine NO...

normal config on beta10:
M574 X1 S0 P"io0.in"

Duet3

Do all home X, Y work fine? Am I the only one? show homex.g
On beta10

G91 ; relative positioning
G1 Z5 F6000 H2 ; lift Z relative to current position
G1 H1 X-335 F1800 ; move quickly to X axis endstop and stop there (first pass)
G1 X5 F6000 ; go back a few mm
G1 H1 X-335 F360 ; move slowly to X axis endstop once more (second pass)
G1 Z-5 F6000 H2 ; lower Z again
G90 ; absolute positioning

work good.

On beta11 goto Z5,Z-5,X5.. but does not go to the microswitch.

On update 10->11 not work homex(y)(all) files. Change S1 to H1..

G91 ; relative positioning
G1 H1 X-355 F1800 ; move quickly to X axis endstop and stop there (first pass)
no reaction to the command at least earlier moved where necessary.

Immediately provide 0.

G91
G1 X-5
NOT WORK TO! IF X = 0

@bearer yes, work. install beta11

@bearer 3.0beta10.. need 3.0beta11

How to update Duet 3? Upload Duet3Firmware_MB6HC.bin on web.. and nothing.
M997 S0
Error: In-application programming binary "Duet3iap_sd_MB6HC.bin" not found
where Duet3iap_sd_MB6HC.bin?
not have rapsberry pi...

@triumphantduke Does it make sense in SBC on a regular printer with 4 motors? What is it that they all rush about with it?

YES, in 8 work. thx

Maybe you need PWM on the orange cable? On https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview have SERVO pin.. Where is he? It doesn’t work for me either. There is no instruction where to connect which cable.