@Phaedrux Hello @Phaedrux

I will give the M500 a shot then resort to a complete rebuild of the image for the PI.

@chrishamm I will give it a try

@Phaedrux Any insight to my issue?

@Phaedrux

Here is the Firmware and Software Versions:

Board: Duet 3 MB6HC (MB6HC)
DSF Version: 3.4.5
Firmware: RepRapFirmware for Duet 3 MB6HC 3.4.5 (2022-11-30)
Duet Web Control 3.4.5

The odd thing is raspberry pi name is Railcore300
The board name is Railcore300

The browser on the raspberry pi states the "Railcore 300" cannot be found.
I can open the page on the raspberry pi and another computer by IP without issue. The page is available with http://railcore300.local/

Thank you again for the help.

Hello
I used the sudo shutdown so I could do some work on my Railcore 3D printer. Later after start up the DWC webpage on the raspberry pi states it could not be found by the name of the printer/sbc.

If I communicate with it by IP from a another computer. The page shows up.

How do I restore/fix the local instance?

Steven