Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Tasos
    • Profile
    • Following 0
    • Followers 0
    • Topics 1
    • Posts 4
    • Best 0
    • Controversial 0
    • Groups 0

    Tasos

    @Tasos

    0
    Reputation
    1
    Profile views
    4
    Posts
    0
    Followers
    0
    Following
    Joined Last Online

    Tasos Unfollow Follow

    Latest posts made by Tasos

    • RE: Delta bl touch auto leveling

      OK i change the P9 to P5 and also Z2 to Z1 and now works
      i run mesh and i got this

      Number of probe points: 109

      Probe area: 452.4 cm²

      Maximum deviations: -0.633 / 0.027 mm

      Mean error: -0.273 mm

      RMS error: 0.161 mm

      0_1523660226736_Capture.PNG

      I m not sure if this is right

      posted in Tuning and tweaking
      Tasosundefined
      Tasos
    • RE: Delta bl touch auto leveling

      @dc42 No i tested again the same story, nothing shows up in the console.
      I think the problem is somewhere else , my thought is why it shows me inDWC the manual bed leveling . It supposed to do itself right?.

      posted in Tuning and tweaking
      Tasosundefined
      Tasos
    • RE: Delta bl touch auto leveling

      @dc42 yes all tests that i ve tried is with P9 and with P5 but the results are what i have described above

      posted in Tuning and tweaking
      Tasosundefined
      Tasos
    • Delta bl touch auto leveling

      Hello i bought duet ethernet as an upgrade for TLM ,the wiring and the first calibration of the machine was easy to complete and everything went fine.
      The problem is with bl touch and the auto-leveling ,i follow these instructions,https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe,https://betrue3d.dk/bltouch-on-duet-wifi-duetreprapfirmware/.
      .
      So the when the machine powers up bl touch is self tests and everything is ok ,even when i manually touch the bl touch it triggers.
      But when i hit the delta auto leveling in DWC the efector goes to the trigger height (set it in config.g) the bl touch pin goes down,but doesn't probe the center waits some ms and the moves to the first tower and suddenly the DWC shows the manaul bed leveling in which i have to move down the z axis until the bl touch triggers and if do that the bl touch after the first trigger goes to error mode (RED led blinks) and even if move to the next point the bl touch doesnt respond 0_1523357488108_bed.g 0_1523357491506_config.g 0_1523357494231_homedelta.g

      posted in Tuning and tweaking delta bl touch auto leveling little monster
      Tasosundefined
      Tasos