Topics created by TimV 0

@TimV-0

I kept the ender5 limit switches but replaced the wiring with generic 3 pin wires to the board. I am having problems keeping the wires connected at the end stops.

With proper connectors, this should not happen. Maybe the wires are too "generic"?

I applied heat shrink tubing at the limit switch end, so they now all look perfect but seem to vibrate loose.

Cosmetics cannot hide the face below for long 👺. Use proper connectors or a good soldering iron - the switches are just fine.

@TimV-0 is it a 5" integrated PanelDue, or a non-integrated one? If it is non-integrated, what PCB version is it?

If it's an integrated one then you can check whether the backlight inverter is working by measuring the voltage across the capacitor labelled C3 near the top right hand corner (looking at the back) of the PCB. It should be about 17V. Note, it can be difficult to get a good connection to SMD components when using a multimeter, because of oxidation on the surface of the lead-free solder.

Yes incorrectly wired endstops could cause the board to reset.

Your config looks ok to start the wifi module on startup.

Send M587 by itself in the console to see what wifi SSIDs are currently saved. Ideally there should be only 1.