Thanks for the prompt re[ly, I will look out for the setup option. 180 deg will be fine. I had noted thread regarding 90 deg problems, hence thought best to ask!
Trackpin

Hi,
Restarting a Workbee build and looking at mounting an i7 panel at 45 degrees in a pre existing 3d printed enclosure. Ideally would like to rotate screen output and leave erase/sounder/reset holes where they are, rather than hack enclosure, or rework/reprint. Can the screen orientation be changed in firmware? Have done this in a Pi3 project but have no experience (yet!) of the finer points of Duet/Reprap. Any help appreciated.
Trackpin