When changing from the penultimate outer line to the outer line no retract takes place.

Supplement to the steps .....

M92 X1009,000 Y1010,000 Z201,000 E2075,000

Matematically there would be a little delay.

greetings

The drain is in the outline as follows ....
When changing to the outer line is at the beginning of a minimal
over extrusion. At the end, parameter: M572 D0: 1: 2 S0.06
so that a clean spout is guaranteed.
The values of the X and Y axes are in the Acceleration and Jerk ranges
M201 X1050 Y1050 Z200 E2000
M566 X2100 Y2100 Z10 E1000
I definitely have a problem that the extruder runs minimally in advance.
I do not doubt that the temperature is a bit too high. But this is due to the strength of the component.

I made a high-resolution image in which I marked some places

Is there a way to delay the extruder when switching to the outer line?

Thanks for your help

Best regards

Heiko!

Hello everybody,
Please excuse following my english but google tries his bestets.

To my problem .....
I have small blobs with the slicer (S3D) are not get away.
This is not due to the settings of the Slicers.
The extruder is operated with the standard driver of the Duet Ethernet.
The axes X, Y & Z are operated via external drivers.
My guess:
The signals to the external drivers are delayed;
X, Y, Z
step timing 3.2.3.2.5.3.5.3 microseconds

not to the extruders;
Extruder´s
step timing 0.0,0,0,0,0,0,0 microseconds

Thus, in the outline of the start of the axis to the extruder is not synchronous and the axis starts delayed with the extruder starts immediately.

Is it now possible to increase the times of the extruder to achieve a delay?

Please kruze info if this way of thinking is right or there are other ways to synchronize / delay.

Best regards

Heiko