@jay_s_uk ok I try
Latest posts made by Raffa2s
-
RE: WiFi reported error: no known networks found
@jay_s_uk I just write it right but it's appears like that, is it normal?
Octoprint as terminal was used -
WiFi reported error: no known networks found
Hi,
In the last few days, I had tried to connect to my Duet2 wifi as always but I couldn't (server unreachable). I had tried to reset the firmware but nothing... How can I fix that?
Down below you can find the state of M587 and M552 S1, after that the error "WiFi reported error: no known networks found" even if the wifi is listed.Send: M587 Recv: Remembered networks: Recv: CASARAF IP=192.168.1.29 GW=0.0.0.0 NM=0.0.0.0 Recv: ok [...] Send: M552 S1 Recv: ok [...] Recv: WiFi reported error: no known networks found Recv: WiFi module is idle
thank you
-
RE: E3D V6 original Temperature problem
@Phaedrux
I followed the E3D guide but it was to low, my room temperature is 25 C and I measured the hotend temp with a K-type sensor.
I had tried several temperatures (from 200 to 245 C) and with a B4725 the result was off by 12 to 20 degrees. Now I had found a good spot at B5000.
I don't know if but at the moment it is working so I don't touch anything.
Thank you all for the support -
E3D V6 original Temperature problem
Hi,
I had an original E3D v6 with original thermistor, and I'm at the latest firmware (3.1.1) for my Duet 2 WiFi.
I had a problem with the temperature, in fact if I use the original setting (down below) the real temperature is 20 C lower than the one set, how can I fix this?M308 S1 P"e0temp" Y"thermistor" T100000 B4725 C7.06e-8
At the moment I fix it increasing the B parameter like so:
M308 S1 P"e0temp" Y"thermistor" T100000 B5000 C7.06e-8
Thank You