Need help to define Z max endstop
-
@veti Same problem...
-
-
@Olivier what does M119 show when you have the Z switch triggered?
-
M119
Endstops - X: not stopped, Y: not stopped, Z: at min stop, Z probe: at min stop -
@olivier
issue the command
M574 Z2 S0check M119 when the endstop is not triggerd
hold endstop
check M119 again -
@veti said in Need help to define Z max endstop:
M574 Z2 S0
14:12:13M119
Endstops - X: not stopped, Y: not stopped, Z: not stopped, Z probe: not stopped
14:12:04M119
Endstops - X: not stopped, Y: not stopped, Z: at max stop, Z probe: not stopped
14:11:58M574 Z2 S0 -
My macro :
M574 Z2 S0
G1 Z300 F3000
M574 Z1 S2 ; Set endstops controlled by probeIt was inverted so I put the command M574 Z2 S1 but it not stop anyway...
-
@olivier said in Need help to define Z max endstop:
There is no endstop command in your macro and it seems you need to invert the endstop
tryM574 Z2 S1
G1 Z300 F3000 H1
M574 Z1 S2 -
@veti said in Need help to define Z max endstop:
G1 Z300 F3000 H1
You're right !! it work now
Thanks a lot.I will try the stall detection now
-
i still dont understand what you want to achieve with this.
-
If I need to lower the bed without homing and without clicking several time on Z axis move
Stall detection works perfectly too