Soft reset procedure?
-
Hi,
After issues commented in another post... I dlike to do a soft reset of Duet....
I can't find the procedure for do a soft reset...
What are the steps? Exists a hard reset procedure?
-
the soft reset is the command M999
https://duet3d.dozuki.com/Wiki/Gcode#Section_M999_Restart -
I have try soft reset.... Erase macros and gcode files.. But no, config.g....
And the same problem with fans...
I am searching a procedure for factory default
-
-
@peirof the closed you get to a "factory default" config would be
https://github.com/T3P3/Duet/tree/master/Duet2/SD Card Contents
but those are just for testing.I would either continue to work with your existing config, or generate a new one with the https://configtool.reprapfirmware.org
-
My intention was to test if the two of the fans did NOT work, and gave a voltage lower than 24v, was due to a configuration failure ... but it does not seem likely ...
What other options do I have?
Try a downgrade?
-
The duet fan voltage is either vin or 5v depending on how the jumper is set.
the duet uses a pwm signal on the negative to slow down the fans.at 100% no pulsing is taking place
post your
M106
from your config.