2.03 + PanelDue 7i
-
So that is what the other cable that came with the panel is for? I can try it later.
-
The 4 pin connector is the preferred method of connection. It's far more robust and less prone to connectivity issues. The cable length can be much greater as well.
-
You will still need the ribbon cable if you are using the SD card slot on the paneldue, but you only need the 4-wire otherwise.
You can also plug both in and it should work fine.
-
Check that you have the ribbon cable connected to the right port on the Duet, which is CONN_SD, not CONN_LCD despite the name.
-
Shouldn't the firmware on the PanelDue show the interface and not a white screen as long as it has sufficient power regardless of communication with the Duet? -
-
I connected the 4wire connector and it is working fine. Now do I connect the ribbon cable to the blue circle or the orange circle?
-
Unless you need to use the SD card in the PanelDue, i would not.
As @Phaedrux mentioned, you can have a longer cable with the 4 pin, the ribbon cable has a length limit.
I upload everything from a computer via a network so no need for the PanelDue SD. -
@kthoma85 said in 2.03 + PanelDue 7i:
blue circle or the orange circle?
The blue one marked "External SD Card" will also power the PanelDue.
-
Thank you everybody. I am good to go now.
-
@bearer said in 2.03 + PanelDue 7i:
Shouldn't the firmware on the PanelDue show the interface and not a white screen as long as it has sufficient power regardless of communication with the Duet? -
Yes, if the ribbon cable is sound and connected to the correct connector on the Duet.
