limit switch
-
hi everyone i think im close but the limit switches are not correct they are on all the time and off when the switch is tuched by the carridge.
-
You want the switches to be normally closed like you said and when they are activated, they open. I remember reading that you have less interference that way and don't get false trips on them.
-
can probably invert it by changing the
Sparameter toM574
https://duet3d.dozuki.com/Wiki/Gcode#Section_M574_Set_endstop_configurationor rewire as pr james' post if they're not already normally closed.
-
can i set it in firmware if so how
-
@akluge No; You set everything in
config.g, which is read when the Duet boots up. There is nothing to 'set' in the firmware, start at the top of the documentation tree to see how setup is done the Duet way.
