got it set up thanks for all the help

how do i change direction of stepers on maestro

can i set it in firmware if so how

hi everyone i think im close but the limit switches are not correct they are on all the time and off when the switch is tuched by the carridge.

@Danal thanks for the help that worked now i need to change the limit switches from constatnt on to on when the switch is triped

hi i am tring to wire my nema 17 steppers i purchased from matter hackers to a duet maestro i have the red and green wires as a pair and the yellow blue wires as a pair but i dont know what is a and b. how do i wire them to the maestro i followed the picture but i get the error stepper wire grounding error. i have the red and greeen on outside and blue and yellow on inside.

got it set up thanks for all the help

@T3P3Tony Sorry it is a home system

@T3P3Tony When i run M552 S1 i get nothing it just says ok. now was I supposed to get a USB cable with my board if so i did not is this the reason it is not working i am using just a USB cable i have I cant get a ip adress

i have tryed with just the usb and with both usb and eithernet

so i have went through the directions and got to step 18 when i tryed to enter M997 S0 like it says and that did nothing. so than i tryed M552 and got an ip of 0.0.0.0 that does not work either.