M666 tower Y
-
the firmware is 2.04.
even after the G32 calibration, the Y tower is outdated by 0.5 degrees
-
@Veti said in M666 tower Y:
which factor calibration are you running?
you did not answer this question
-
@Veti said in M666 tower Y:
which factor calibration are you running?
Sorry, but I do not understand!
what do you mean? -
see
https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer
section
Setting up the bed.g file -
thanks! but I don't understand where to go to change.
I am attaching my bed.g. can you help me?
-
Its the S parameter on the last command.
i take it you wan the 8 factor calibration? put S8.
-
@Veti said in M666 tower Y:
Its the S parameter on the last command.
i take it you wan the 8 factor calibration? put S8.so i have to replace s6 with s8 right?
sorry but it's my first experience with the duet!
-
yes
8-factor: as 6-factor but also adjusts the X and Y tilt angles (M666 A and B parameters).
-
@Giusva said in M666 tower Y:
but at each print running the G32 t
also there is no need to run G32 every print. you save the paramters in the config.g
see the article about saving
-
@Veti said in M666 tower Y:
also there is no need to run G32 every print. you save the paramters in the config.g
see the article about savingok! so once changed s6 with s8 I redo the g32 and it should be ok?
-
