@Veti said in M666 tower Y:

also there is no need to run G32 every print. you save the paramters in the config.g
see the article about saving

ok! so once changed s6 with s8 I redo the g32 and it should be ok?

@Veti said in M666 tower Y:

Its the S parameter on the last command.
i take it you wan the 8 factor calibration? put S8.

so i have to replace s6 with s8 right?
sorry but it's my first experience with the duet!

thanks! but I don't understand where to go to change.
I am attaching my bed.g. can you help me?

@Veti said in M666 tower Y:

which factor calibration are you running?

Sorry, but I do not understand!
what do you mean?

the firmware is 2.04.
even after the G32 calibration, the Y tower is outdated by 0.5 degrees

Hi, sorry for my english but I use google trasletor!
I wanted to know if there is a way to adjust the tower y saddle degrees which is 0.5 degrees off.
I tried to modify the parameters in M666 but at each print running the G32 they return as they were originally.
Predator printer with smarteffector.