CR-10S5 Firmware

[Gost101]

@Veti said in CR-10S5 Firmware:

while printing please post the output of the commands M201 till M205

How does one do that?

[Veti]

@Gost101 said in CR-10S5 Firmware:

z retraction.

its called z hob wgeb retracted

[Veti]

@Gost101
in DWC go to console and issue the commands under send commands

[Gost101]

@Veti said in CR-10S5 Firmware:

M201

Cool beans, about to try new test.

[Veti]

did you turn on adaptive layers?

[Gost101]

@Veti Should I? Also here is the M201 and M205 command posts:

[Phaedrux]

@Gost101 no don't turn on adaptive layers.

Your speeds are still being limited. Did you send these m201 etc commands after a reboot of the duet?

[Veti]

@Gost101 said in CR-10S5 Firmware:

Should I?

no but from the g code file it looks like you do.

[Gost101]

@Phaedrux @Veti Ill reboot it again. Currently the test print keeps pausing mid print. Weird???

[Phaedrux]

It probably just looks like pausing because the speeds are so low.

If you run a gcode file that has the slow settings from Cura it will remain in effect until you restart the duet and the proper settings get loaded from config.g

[Gost101]

Now its printing fast, but its printing as if its on crack, so. Here is a video of it: Printer on Electric Crack

[Gost101]

@Phaedrux @Veti I'll post how the bench goes after some speed tweaks.

[Gost101]

Here is the benchy it took almost 5 hours. But the printer is almost perfect. I will upload all of my files after further testing.

[Veti]

what about your adaptive layer settings?

[Gost101]

@Veti
Adaptive layers were never enabled.

[Gost101]

Here is the profile I'm currently using: Cura Profile

[Gost101]

Also, I will be printing a adapter for my volcano and try that again down line. As of right now, I'm just tweaking things.

[Veti]

@Gost101

then you have something else wrong with the layer heigh.

Z0.144
Z4.194
Z6.554
Z7.074

those are very odd layer heights.

[Phaedrux]

@Gost101 said in CR-10S5 Firmware:

Here is the profile I'm currently using: Cura Profile

I'm unable to open the profile in cura 4.4.1. Says it's invalid. But unzipping it and looking at it in a text editor shows that your print speed are super slow. 15mm/s to 30mm/s which would explain the 5 hour print time.

If my Ender 3 can handle 50-60mm/s I'm sure your CR-10 could as well. Such low print speeds on such a small object can lead to overheating which your image shows some indication of. So try boosting the print speeds a bit more.

[Phaedrux]

Here's my Ender3 profile as an example.

https://www.dropbox.com/s/l3v1i0ca0dbgau9/Ender3CuraProfile.curaprofile?dl=1