Cool beans, increased trouble shooting will start tomorrow later today. I will be back sometime tomorrow with the results.

Then I will work on the ultimate printer project which will take 1 year + to finish. I appreciate all the help that you all provide @fcwilt @droftarts @Thalios @Phaedrux @dc42. Will there be an expansion board in which I could plug in my own stepper driver? Curious about testing a closed loop system.

There was a short, on the z stop. However now I will begin troubleshooting as to why the motors are not working.

@alankilian @I have 5 closed loop stepper drivers for context. Can I connect all of the closed loops stepper drivers to the same 5V and Ground Terminal or would that break something?

I made a quick wiring diagram in paint.

@alankilian Thats what I thought but wasn't entirely sure. I'll let you know if it works, when I get back home.

@alankilian Is there a 12v connector on the board I can use?

@alankilian Which Pin connector should the GND, 5V/3.3V, & Power 12V/24V connect to on the Expansion board?

@phaedrux I have, no luck.

@alankilian @JoergS5 Does this mean you guys can help me? I have no idea as per which connector on the breadboard connects to which connector on the closed loop board.

@phaedrux I have seen that post and no I am not familiar with the wiring of the closed loop driver that's why I asked LOL. Do you know anyone who might be?

@phaedrux The Panel Due now works. Thanks. But how should I wire the stepper motor drivers from the breakout board?