Overview of implemented Gcode RRF3 for Duet3+Pi

[mvieleers]

Is there an overview available of all Gcodes that have been implemented in DWC for a RRF 3(.01-RC2) Duet3+Pi combination?
I've ran into a situation that M500 has not been implemented, but I also noticed that M291 is not working.
It would be helpful to understand what can and cannot be used.

Thank you!

[Phaedrux]

Something like this?

https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview

[A Former User]

Its the best overview available, but its not perfect - M291 was only added recently. Do post if you find other exceptions.

[DocTrucker]

M500 not working isn't mentioned in the guide. Is that related to the autotune on remote cards not working either?

[A Former User]

@DocTrucker said in Overview of implemented Gcode RRF3 for Duet3+Pi:

M500 not working isn't mentioned in the guide.

sure it is;)

i think its related to the fake sd card not sure.

[deckingman]

@bearer said in Overview of implemented Gcode RRF3 for Duet3+Pi:

.................................Do post if you find other exceptions.

As of latest firmware release (3.01-RC2), M950 now has a J parameter. These have all changed too as per the "What's new"

If you use M577 or M581 commands, you will need to change them.
If you use M143 commands with P or X parameters, you will need to change them
If you use M558 commands with the I parameter, you will need to change them

but the overview that @Phaedrux linked to doesn't reflect the changes

[gtj0]

@DocTrucker said in Overview of implemented Gcode RRF3 for Duet3+Pi:

M500 not working isn't mentioned in the guide. Is that related to the autotune on remote cards not working either?

M500 doesn't work with the DSF/SBC for any heater because we're waiting on @chrishamm to implement support for getting the values from the Duet and writing them to the config-override file. AFAIK it works in standalone mode (at least for local heaters).

[mvieleers]

@Phaedrux thx! Read a lot, but never stumbled upon that page strangely enough.

[DocTrucker]

@bearer nice one...

But I searched document for "M500". [checks edit history] Ah ha!

[chas2706]

@gtj0 said in Overview of implemented Gcode RRF3 for Duet3+Pi:

M500 not working isn't mentioned in the guide. Is that related to the autotune on remote cards not working either?

M500 doesn't work with the DSF/SBC for any heater because we're waiting on @chrishamm to implement support for getting the values from the Duet and writing them to the config-override file. AFAIK it works in standalone mode (at least for local heaters).

I hope @chrishamm remembers to sort G32 not reporting any output and having to enter commands in the console twice before they work!