Config.g for tronxy x3

Snape6666

Hi everybody,

I just bought a duetwifi and tried to configure it for the tronxy x3 (http://www.gearbest.com/3d-printers-3d-printer-kits/pp_436307.html?vip=778571&gclid=CP3StLXfy9ICFdW4GwodAE8FpQ).
All motors are working fine and the low-endstops work too.

My problems at the moment are:
-heater is able to preheat, but when i start the testprint i get a T0 fault and it stops

Do you know why the heater stoped heating? 30 min before it was working fine… but after setting up the max speed and acceleration it just troughing the fault...

May you help me to setup the config.g file for my tronxy? Iam a novice in 3d printing...

Thanks for help!

T3P3Tony

Welcome to the forum.

Have a look at this part of the wiki:
https://duet3d.com/wiki/Tuning_the_heater_temperature_control

Give that a go as it is the likely cause of a working heater giving temp faults.

Snape6666

hm… I just saw that my console dont stops writing:

"Attempt to move the head of a delta printer before homing the towers"

What could be the problem ?

dc42

@Snape6666:

hm… I just saw that my console dont stops writing:

"Attempt to move the head of a delta printer before homing the towers"

What could be the problem ?

What it says. You tried to print before you homed the printer. Or you turned the motors off at the end of the previous print, so the firmware can't be sure of the head position any more and you need to home it again before you do another print.

Some people use G28 in their slicer start gcode to make sure the printer is homed before printing.