hm… I just saw that my console dont stops writing:

"Attempt to move the head of a delta printer before homing the towers"

What could be the problem ?

Hi everybody,

I just bought a duetwifi and tried to configure it for the tronxy x3 (http://www.gearbest.com/3d-printers-3d-printer-kits/pp_436307.html?vip=778571&gclid=CP3StLXfy9ICFdW4GwodAE8FpQ).
All motors are working fine and the low-endstops work too.

My problems at the moment are:
-heater is able to preheat, but when i start the testprint i get a T0 fault and it stops

Do you know why the heater stoped heating? 30 min before it was working fine… but after setting up the max speed and acceleration it just troughing the fault...

May you help me to setup the config.g file for my tronxy? Iam a novice in 3d printing...

Thanks for help!