CR10S Bondtech E3D, Dual Z outputs - Cura Settings.
-
I am new to the Duet wifi (Just Set up the first time ) and was wondering if anyone had a good starting point for the configuration od X,Y and Z
Microstepping (interpolation)
Max. Speed Change (mm/s)
Max. Speed (mm/s)
Acceleration (mm/s²) Motor Current (mA) using stock motors except extruder is a pancake.If anyone can give me a cura profile they use to get me started I would appreciate it.
-
Most of the things you've asked for should be in the config.g on the printer, not in Cura.
See https://configtool.reprapfirmware.org/ for a great way to get started.
-
it is a great way to get started which is where I am @ but I wanted to know what settings users found works best instead of default values.
-
@Turricann said in CR10S Bondtech E3D, Dual Z outputs - Cura Settings.:
it is a great way to get started which is where I am @ but I wanted to know what settings users found works best instead of default values.
microstepping of 16x with interpolation is best 99.9 percent of the time.
Speeds and accel are HIGHLY dependent on your mechanics. A CR10s is going to work pretty well on the defaults. Anyone with a CR10s on duet should chime in, if they've found any fine tuning.
-
@Turricann As a CR10S is pretty much the same as an Ender 3, see @Phaedrux guide here: https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+2:+Configuration/38#s125
If you have a copy of the CR10S Marlin configuration, you can get the stock settings from there. Be aware that Marlin defines things in mm/second, which RepRapFirmware uses mm/minute.
Ian