No USB port in Paneldue 7 " firmware installation

[aego]

@bearer

[A Former User]

most interested in the solder joints on the usb port (red circle)

but isn't the 4 pin connector damaged or reversed? (yellow cicle)

[aego]

(white ) from Din (board) to VTX DO ( Duet 2 wifi)
(black ) from Dout (board) to VRX DO ( Duet 2 wifi)

[A Former User]

looks like the order of the connectors are correct, but the connector looks reversed (but its not likely to be the problem)

anyways, a closer picture of the USB port, and better lighting please.

[aego]

[aego]

@aego
the welds seem ok to me

[A Former User]

possibly. a little light on solder paste for the socket, but pins look okay at a distance.

the 4 pin connector isn't connected to anything when you're trying this right?

if so sounds like you should check the warranty terms with your vendor and report back.

[aego]

@bearer said in No USB port in Paneldue 7 " firmware installation:

all 4 pins are connected. Should I disconnect the White (Din) or Red (+5v) pin?

[A Former User]

@aego said in No USB port in Paneldue 7 " firmware installation:

all 4 pins are connected.

to both the PanelDue and the Duet? if yes, try disconnecting all 4 from one side just to be sure.

[aego]

Now after desconnecting all pins, the USB port appeared.
I triggered the Write button, started the process and was soon interruped with the following error message " Flash command failled"

[droftarts]

@aego I was going to say you need to disconnect the PanelDue from the Duet, but you seem to have done that now.

See https://duet3d.dozuki.com/Wiki/PanelDue_Firmware_update for flashing instructions.

Did you check the Erase all, Lock, and Boot from flash boxes?

Ian

[A Former User]

@aego said in No USB port in Paneldue 7 " firmware installation:

I followed the instructions at https://miscsolutions.wordpress.com/paneldue/,

no you didn't

[aego]

Yes, I triggered Erase and Reset buttons. I'll reread the instructions and if I jumped anything, I'm sorry

[aego]

@aego
Anyway there was evolution thanks to bearer
my thanks

[aego]

@aego
Bearer you are right, I did not check the Erase all, Lock, and Boot from flash boxes. My failure to read the instructions quickly. Again sorry and thank you, thank you very much