Connecting to Duet3 with Macbook
-
@bearer Bossa Program Port (COM9)
-
@meatfest said in Connecting to Duet3 with Macbook:
Bossa Program Port (COM9)
see https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware#Section_Fallback_procedure_Num_3
you can go straight to using the Bossa program as the firmware is already erased.
-
@bearer also the diag led is dimly lit all the time, either with or without the erase pins connected...
-
@meatfest said in Connecting to Duet3 with Macbook:
also the diag led is dimly lit all the time
That means that the firmware has been erased. It should flash once a second if firmware is running. Also note that the Bossa program doesn't work on Mac OS to flash Duet 3 (it does work with Duet 2) so use a Windows PC to flash the firmware.
Ian
-
I switched to my Windows 10 machine for now, I just want to get it working. I will look at re flashing firmware.
-
@meatfest still stuck. let me re-cap.
I have Duet3D board.
I am using Windows 10 (stopped using my Macbook Pro)
I have installed Bossa and Sam-Ba
I have updated the driver for USB and it shows Bossa Program Port (COM 9) in Device Manager.
With Sam-ba I get message:
Error h_handle returned zero
while executing
"TCL_Open $target(connection)" ....
With Bossa I get the message:
Could not connect to device on COM9 -
@meatfest It sounds like something is still connected to the Duet on COM9. I'd suggest restarting your PC, then just use Bossa to flash the Duet.
Ian
Bed-slinger - Mini5+ WiFi/1LC | RRP Fisher v1 - D2 WiFi | Polargraph - D2 WiFi | TronXY X5S - 6HC/Roto | CNC router - 6HC | Tractus3D T1250 - D2 Eth
-
@droftarts rebooted, same message from Bossa...
Could not connect to device on COM9
-
While its possible there is a problem with the board, all the other instances has turned out to be issues with software or usb cables.
As such I think it could be worth while trying to build bossa from sources on the Mac and see if it makes a difference after applying a patch to the code.
Is cloning code with git and running make to build it something you're comfortable with on the Mac?
-
If you happen to have a Raspberry Pi, there are instructions on the Dozuki to set it up and try it. They are sometimes better at finding the bossa port. Sometimes.
-
@meatfest said in Connecting to Duet3 with Macbook:
@droftarts rebooted, same message from Bossa...
Could not connect to device on COM9
Which version of Bossa are you using?
-
Success!
In device manager I selected show hidden devices and found two instances of Bossa one was inactive the other active. I deleted both and reconnected and then when I selected the new com port I ran write and verify and all was well. It seemed that Windows held onto two com ports , one was hidden thus causing the problem. Something to bear in mind!
-
-
This post is deleted!
