Hotend modes "off", "standby", "active"

[mwolter]

@Plohish You're welcome. For some reason, this info a little difficult to find. Glad I could help.

[Plohish]

little problem

comand G10 P0 S-273.15 R-273.15 disables the hot end and sets the temperature = 0 in the web interface, but on the panel the temperature remains the one that was set.
firmware Release 3.0

[Phaedrux]

@Plohish Please update your firmware to 3.1.1 and the Panel to 1.24 and see if that still holds true.

[Plohish]

@Phaedrux my panel has firmware 1.24
Today I’m not ready to upgrade the Duet to 3.1.1, maybe I will do it later

[Phaedrux]

@Plohish Its a much easier upgrade than going from 2x to 3x.

[Plohish]

the ATX OFF button from the web interface turns off the printer even if the hot end has a temperature above 45 degrees, is this normal?

[Plohish]

@Phaedrux I changed the firmware to 3.1.1
this did not help me solve the problem incorrect display of temperature on the panel

[OwenD]

Yes it’s normal if you just send M81
Use S1 parameters

M81 ; turn power off immediately
M81 S1 ; turn power off when all thermostatic fans have turned off

[Plohish]

@OwenD I thought the duet button is much more intelligent and understands that turning off is not desirable
I know about M81 S1 doing it from a macro

[Phaedrux]

@Plohish said in Hotend modes "off", "standby", "active":

@OwenD I thought the duet button is much more intelligent and understands that turning off is not desirable
I know about M81 S1 doing it from a macro

Perhaps @chrishamm can make that configurable?

[Plohish]

@Phaedrux What do you think about the problem of displaying temperature on the panel?

[Phaedrux]

@Plohish I'm not sure about that part either.