Added Duex5 - Really need some help
-
When I try to home it stays busy and the arrow circles spins and then I get a homing error.
Same with either x or y. Same if I comment out the raising of z before I home.Motors are plugged into:
X in 0
Y in 1
Z in 2
E in 3 or E0
U in 4 or E1Well what do you know. With the duex removed and U removed from M92, it homed correctly.
With the duex reconnected and U removed from M92 - no movement and driver 5 error is back. -
I need to leave for about 90 minutes
-
@GeorgeM said in Added Duex5 - Really need some help:
Well what do you know. With the duex removed and U removed from M92, it homed correctly.
With the duex reconnected and U removed from M92 - no movement and driver 5 error is back.The first point I expected. The second point is still perplexing.
What happens with duex connected and M92 U removed?
-
@Phaedrux said in Added Duex5 - Really need some help:
What happens with duex connected and M92 U removed?
With the duex reconnected and U removed from M92 - no movement and driver 5 error is back.
-
As a sanity check, I configured X to use driver 5. When doing so I get no movement from X motor.
-
How have you the Duex wired?
https://duet3d.dozuki.com/Wiki/Duex2_and_Duex5_Features#Section_Wiring
-
@Phaedrux said in Added Duex5 - Really need some help:
How have you the Duex wired?
https://duet3d.dozuki.com/Wiki/Duex2_and_Duex5_Features#Section_Wiring
Exactly like that.
-
I think you have a failed driver 5 on your Duex. When was it purchased and from where?
-
@Phaedrux said in Added Duex5 - Really need some help:
I think you have a failed driver 5 on your Duex. When was it purchased and from where?
June 26 from Filastruder. I contacted Tim there and gave him the link to this thread.
-
Well at least our endeavour wasn't totally fruitless.
-
I do appreciate all your attention to this. You were able to get me corrected about the U parameters. That's a win.
I do need to start a new thread about why my laser wont operate from gcode commands.
