Macros on PanelDue's Control Screen

oozeBot

@Phaedrux thanks for the photo. What I am experiencing on a Duet 3/RPi is that no macros are showing up on the Control tab of the PanelDue. My suspicion is this is a defect that has gone unreported until now. It was just recently that the defect was corrected that allowed Macros on the RPi's SD card to even show up on the PanelDue (I'm the one that reported it). This feels like a similar scenario. Would you please ask @dc42 and/or @chrishamm to review this?

OwenD

@oozeBot
I don't run a pi, so can't be sure if it's the same, but on the D2, macros will only show on that screen if they are placed in the root of the macros folder.
Anything in a sub folder can only be accessed from the macros page.

oozeBot

@OwenD said in Macros on PanelDue's Control Screen:

@oozeBot
I don't run a pi, so can't be sure if it's the same, but on the D2, macros will only show on that screen if they are placed in the root of the macros folder.
Anything in a sub folder can only be accessed from the macros page.

Good call out - the test scripts are in the root Macros folder. Thanks

Phaedrux

How are they named?

Can you test in standalone mode to isolate the problem to the rpi side?

oozeBot

@Phaedrux there is currently just a single macro in the root macros folder named 01_test.g. It shows up as test.g on the Macros tab, but does not show up at all on the Control tab.

While I understand what you are asking, I do not have any experience running the Duet 3 in stand-alone mode. I suspect it would work as I’ve found several other things that seemed to only break when running from the RPi’s SD card- specifically, no macros displayed on the macros tab before 3.1.1..

oozeBot

@Phaedrux - is there a better way to report defects than forum posts? Github? Thanks

Phaedrux

I've brought it to attention, but it is the weekend after all.

oozeBot

@Phaedrux thank you. Sorry- I didn’t mean it like that.. I’m new to Duet and am literally asking the best method for reporting defects.

Phaedrux

You've found the right place.

wilriker

@oozeBot How many tools have you configured? There is a bug in the current release that for 4 tools or more it won't show macros on the Control tab even though it could still show them for 4 tools (but no longer for 5 tools).

This is fixed in the new PanelDueFirmware 3.2-RC1 that I am about to release now.

Also there was an issue fixed in DuetSoftwareFramework 3.2-beta1 that might have caused this problem.

oozeBot

@wilriker thanks for the response. It was literally just last night I figured this out.

see: https://forum.duet3d.com/topic/9771/synchronize-prompts-between-dwc-and-paneldue/19

I am anxious to test the new release.. thanks!