Can't get part cooling fans running :(
-
I see it now
line 4 and 5 is for the hotend fan that triggers on 45 degree, I only have to put the connector on the FAN1 output which is now connected on a always on output 
Have a lot to learn about G-code
-
Still needed some tuning, but a week ago I did not expect to have a working printer already
-
With a Z axis calibration I sometimes see the number 1000 in red in the status box at sensors Z-probe, but usually it stays at 0 (not in red).
What does that mean? -
It's showing that the probe is triggered. What it shows and how long it shows it will depend on the type of probe.
-
@PhaedruxOk, but why don't I see the number 1000 in red every time the probe triggers during a calibration?
-
What probe do you have?
-
The stock Predator probe with a micro switch
-
-
I changed M558 H30 to H35 in the config.g, but that hasn't changed anything, but the calibration is going damn slow now
-
Well the switch is only going to show triggered when it's depressed, so in normal use it would be very brief.
M558 H is the dive height.
You should consider posting a new thread with your probing issues as it's not related to your initial problem which was solved.
-
Ok thanks, I will create a new topic.
