SSID Changed - can not be found

[pro3d]

So I sold my V-King and are trying to help the customer connecting to his wifi. The SSID has been changed on the router to "Sørensen Sport" and when I try to ender this to the network list it saves but when activating the wifi with M552 S1 it does not find the network

Do I need the original SSID or is there a problem with unknown characters in this name?

[pro3d]

Here is the error from YAT:

ok<LF>WiFi module started<LF>WiFi reported error: no known networks found<LF>WiFi module is idle<LF>

[Phaedrux]

@pro3d said in SSID Changed - can not be found:

Sørensen

I wonder if the ø is an issue.

https://duet3d.dozuki.com/Wiki/Gcode?revisionid=HEAD#Section_M587_Add_WiFi_host_network_to_remembered_list_or_list_remembered_networks

You can send M587 by itself to read back saved SSIDs to see if anything was added sucessfully.

You can also send M588 S"*" to forget all currently saved SSIDs and then try to readd them.

Sometimes sending SSIDs over USB is problematic due to the way terminals send special characters or all capitals, so sometimes it can help by creating a macro on the SD card with the command to add the SSID and then executing the macro.

Example:

; Add default wifi network
;
M291 R"Add default WIFI network? Y/N" P"This will add duetwifi access point." S3 T10
 
M552 S0			; Disable network module
G4 S5			; wait 5 seconds
M587 S"NETWORKNAME" P"PASSWORD"			; Add duet wifi SSID to remembered networks list
G4 S5			; wait 5 seconds
M552 S1			; reenable wifi module
 
M291 R"duetwifi SSID added." P"Check console to verify IP address."

; Clear all wifi networks
;
M291 R"Clear WIFI networks? Y/N" P"Caution. New network must be added." S3 T10
 
M552 S0			; Disable network module
G4 S5			; wait 5 seconds
M588 S"*"			; Clear all saved wifi networks
 
M291 R"WIFI networks forgotten." P"You must add a new WIFI network."

[pro3d]

@Phaedrux

The networks seems to be saved:

M587
Remembered networks:<LF>Sørensen Sport IP=0.0.0.0 GW=0.0.0.0 NM=0.0.0.0<LF>ok<LF>

[Phaedrux]

If possible I would try testing with a simplified SSID such as sorensonsport no special characters, no capitals, no spaces.

[Phaedrux]

Also, are you sure the SSID in question is a 2.4Ghz access point? The Duet cannot connect to a 5Ghz network. If possible on the router, create a separate 2.4Ghz network.

[pro3d]

@Phaedrux

It is an access point with 2.4 and 5ghz network. We will try to set up another one with a simple ssid

[Phaedrux]

As a sanity check you can configure the Duet to run in access point mode to see if the wifi module, etc is functioning correctly.

https://duet3d.dozuki.com/Wiki/Gcode?revisionid=HEAD#Section_M589_Configure_access_point_parameters