PanelDueFirmware 3.2.3 released
-
Hi,
My on screen keyboard problem solved, many thanks.
I will waiting V2 board 5" LCD solution -
Not sure why, but after I upgraded paneldue, printer has strange pauses during prints. For about a 3-4 seconds it stops, and then resumes printing. Duet 3 MB6HC 3.2-beta3.2
I had no issues like that with same duet firmware and paneldue 3.2.2 -
@BoA and to confirm, the pauses cease as soon as you disconnect the PanelDue?
-
@oliof What Do You mean by "disconnect"? I have pauses just in the middle of the print without touching paneldue. Only variable seems to be upgrading paneldue firmware.
-
I meant unplugging it to see whether it's just the configuration for a paneldue or the paneldue sending commands.
-
@oliof It is even simpler than that: selecting the Setup tab will stop PanelDueFirmware from sending any commands (except while initializating).
@BoA Can you confirm that the same GCode prints fine when run without the PanelDue, i.e. either cable disconnected, panel on Setup tab or Aux channel disabled via
M575? -
OK. This seems to be coincidence. Printer pauses for a few seconds in random places even without panel connected.
-
Can't figure out why none of v3 firmwares are working on Version 2 PanelDue 7. Chip says that it is ATSAM3S4B. But after flashing does not boot. Last version that works is v1.24
-
@worekarolis I am currently looking into this. I have an assumption I was not able to verify/falsify yet.
-
I have now released PanelDueFirmware 3.2.4 that is mainly intended to fix the issues with v2 boards.
