Heater fault Error.
-
When it's idle, the heater works ok, but when started printing it shows Heater fault error in a few minutes.(or sometimes in a few seconds)
Sometimes it continues up and down about +-20 Degree C.
I thought that the FET for heater 1 has a problem and changed the config setting to use heater 2. But the result is the same.
Does anyone had the same problem ? -
sudden drops or spikes indicate a wiring problem. check the crimping on the cable.
or move the cables by hand
-
@Veti Hello.
Thank you for your comment.
I will check it.
Regards