Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Glue

3D Printing General Chat

2

5

212

Log in to reply

undefined

Touchthebitum
last edited by 20 Dec 2020, 11:34

Hello
I need to glue two flat 3d printed pieces :
One PLA and another one Petg.
Which glue may I have to use ?
Thanks
Sparkcube XL V 1.1 300x300x190, Radds, Raspberry, Keenovo silicone bedheat 220v, Big Booster Extruder, DIY building
BLV Cube 665mm Direct Drive with Duet3/SBC (RPi 4) Mosquito Magnum/Bond Tech Extruder/Vanadium Nozzle, Keenovo silicone bedheat 220v
1 Reply Last reply
Reply Quote 0
undefined

Phaedrux Moderator
last edited by 20 Dec 2020, 17:14

CA glue usually does the trick.
Z-Bot CoreXY Build | Thingiverse Profile
undefined 1 Reply Last reply 20 Dec 2020, 17:29
Reply Quote 0
undefined

Touchthebitum @Phaedrux
last edited by 20 Dec 2020, 17:29

@Phaedrux Thanks
Sparkcube XL V 1.1 300x300x190, Radds, Raspberry, Keenovo silicone bedheat 220v, Big Booster Extruder, DIY building
BLV Cube 665mm Direct Drive with Duet3/SBC (RPi 4) Mosquito Magnum/Bond Tech Extruder/Vanadium Nozzle, Keenovo silicone bedheat 220v
1 Reply Last reply
Reply Quote 0
undefined

Phaedrux Moderator
last edited by 20 Dec 2020, 17:38

Sometimes it helps to rough up the areas that will be in contact to give the glue something to extra adhere to.
Z-Bot CoreXY Build | Thingiverse Profile
undefined 1 Reply Last reply 20 Dec 2020, 17:39
Reply Quote 0
undefined

Touchthebitum @Phaedrux
last edited by 20 Dec 2020, 17:39

@Phaedrux Ok, I'll do that
Sparkcube XL V 1.1 300x300x190, Radds, Raspberry, Keenovo silicone bedheat 220v, Big Booster Extruder, DIY building
BLV Cube 665mm Direct Drive with Duet3/SBC (RPi 4) Mosquito Magnum/Bond Tech Extruder/Vanadium Nozzle, Keenovo silicone bedheat 220v
1 Reply Last reply
Reply Quote 0

1 / 1