I found the problem. It was a loosen screw on one of the x/y motors.
Thanks for your help.
Passion on 3D printing since 2012
Best posts made by Touchthebitum
Latest posts made by Touchthebitum
RE: Firmware bundle 3.3.0 released
I'm trying to enable Plugin on the new 3.3.0 firmware.
sudo apt install apparmor worked
echo " lsm=apparmor" >> /boot/cmdline.txt give me an error message : -bash: /boot/cmdline.txt: permission denied
I can still activate plugin in DSW
RE: Pause/Resume print
I was able to print that piece with this code.
The purpose was to change filament 2 times and modify secondly filament printing settings since they are very different. (PLA and Filaflex). The only missing element is the wait for temperature.
When I press "resume", the carriage doesn't wait for the right temp and goes on printing....
Used gcode :
G0 F7200 X139.597 Y135.325
G1 F1500 X139.423 Y135.499 E0.01154
G0 F7200 X139.552 Y134.522
G1 F1500 X138.306 Y135.768 E0.08264
G0 F7200 X137.99 Y135.235
G1 F1500 X138.858 Y134.367 E0.05757
G0 F7200 X138.208 Y134.168
G1 F1500 X138.018 Y134.358 E0.0126
G1 F1800 E-1
G0 F600 X138.018 Y134.358 Z0.6
G0 F7200 X139.78 Y133.717
M400 ;Wait for buffer to clear
M226 ; Filament Change
M104 S200.0 T0
M117 Extruder 1 Temp: 200.0, Print Speed: 60, Linear Print Speed: 60, Retract Feed Rate: 2.0, Retract Length: 0.1
G1 F900.0 E1.08315;[CAZO:G1 F1800 E1.08315:CAZO]
G1 F1500.0 X140.278 Y133.671 E0.02345;[CAZO:G1 F3000 X140.278 Y133.671 E0.02345:CAZO]
G1 X140.495 Y133.651 E0.01022
G1 X140.616 Y133.639 E0.0057
G1 X140.519 Y133.898 E0.0065
G1 X140.493 Y134.114 E0.00787
G1 X140.393 Y134.931 E0.0386
G1 X140.409 Y135.224 E0.01376
G1 X140.495 Y135.891 E0.03154